New Polaris Winch

New Polaris Winch

Hi everyone. Installing a 4500 rapid recovery winch from Polaris this weekend, 2019 xp 4 turbo. I was sliding it into position and it slipped, landing on the concrete squarely on the end where the selector hub changes it from high/low/neutral. It cracked the plastic...

Trail Armor skid plates ???

Been looking into skid plates and it seems like Factory UTV comes up a lot but I’m really curious on the Trail Armor full skid plates. I really like the built in rock sliders and when taking into consideration this, the price isn’t bad at all considering...

4-seater front harness removal

I have a set of click-6 harnesses I’m going to move from my 1000s to my XP4 Turbo S. I removed the 6’s from the 1000s, and was in process of removing the 4 points from the Turbo S, but ran into a snag. I can’t get to the nut on the outside lower...
New 2 me 2013 570

New 2 me 2013 570

Picked thiss up for a decent $. 1500kms. Its seen a bit of abuse as its got a bit of rock damage underneath as in dents and deep scratches. Motor seems nice and tight. Only issue is the previous owner stored it at a relatives house and they needed the primary clutch...

KMC or Method

Having a hard time deciding on which one. Is one better then the other or is it just a preference I like both of them. In a 15” beadlock. It looks as if the KMC is lighter then the method. Any advice would be greatly appreciated. Utah RZR...

2017 XPT accessories on 2019 XPT

First, took off all of my accessories from my 2017 and thought I would share some differences. Of course dash top is different, I can’t even modify the old SATV flip shield to work, new one ordered. Rockford Stage 1 will fit, but some modification to dash pocket...

Decision Point 800s vs 900s

So, been in a 09 800s for years and we love it. I know I need to upgrade the sagging springs and get shocks rebuilt. I just saw a nice used ’15 900s at the dealer and noticed the differences and changes. Is there a huge difference in the ride and comfort of the...

walker evans shocks

There is a ball joint on each end with the rubber O-rings on each side. Are any or all those parts available somewhere? Wouldn’t it be nice to have grease zerks on them? Thanks Utah RZR...