Wider stance on your 800

So I just picked up my first sxs and it’s a rzr 800. I wanna widen the stance but long travel kits are way more money than I am willing to spend right now. I was looking at MSA M12 Diesel wheels, and you can order them in a -47mm offset (2+5). That alone would take it...

Starting issue

I have a 2011 rzr 800s and having a problem with starting, it tries to turn over once then nothing, tried 2 good batteries, replaced starter solenoid and few days ago we could get it to randomly start (keeps cranking over). Starter going bad? When it does turn over...

Pulling the engine…advice???

So I have to replace the starter bendix in my buddy’s ‘14XC800 and apparently I have to pull the engine to do so. I’m quite mechanically inclined and have no reservations about doing so, but I have a few questions. Do I have to pull both clutches? Do I need to...
2008 RZR 800 front axle issue

2008 RZR 800 front axle issue

Hi first post here. Bought a 08 RZR 800 pretty cheap as it had no front axle shafts and a suspect front differential. Bought a new remanufactured differential and axle shafts. Installed the differential and drive shaft, boy was that roll pin a pain. Installed first...

center / bump seat install with snorkels

Hey all, Im installing a center / bump seat but I have snorkels. I’ve got a few ideas on what I’m going to do with the tubing to get it out of the way, but was wondering what others have done. I was going to have them turn and exit out the side, but does...

Hinge kit

Hi I’m looking g for the left hinge for the lock and ride hard cab the hinge part # is 2855917. These have been discontinued so its gonna be tough to find. Timw60 a member had some along time ago.hope he sees this. Thanks jimmy Utah RZR...