My two bolts up top and the two down low that bolt on the steel bumpers are not catching on the grooves anymore enough to physically tighten them down. It’s like the hole is wallered out. Does anyone know the bolt dimension so I can possibly get something a bit bigger? Is this a common thing for those to become where they can’t be tightened? At first it was just one of them but now it’s all of them. I’ve been using an electric tool to tighten and remove them so maybe they’re only supposed to Be hand tight and I’ve just tightened them too much. Now I need to figure out a way to make the bumper tight again though.

Sent from my iPhone using Tapatalk

Utah RZR Rentals

whence