I started a little LED light strip project. After cutting and soldering the strip, the LED are displaying some sort of voltage drop. Both whips are displaying the same issue after cutting the strips.

These are the strips:

https://www.amazon.ca/Susay-T93007-1…%3F&th=1&psc=1

This where i’m at right now:

I dont think there was voltage drop before cuting the strips. Any ideas? I am a beginner at this stuff. Maybe i didn’t solder correctly? The uncut strip has 1 red and 1 black wire on each end of the strip.

Sent from my iPhone using RZRForums.net

Utah RZR Rentals

whence