i recently bought a use lightbar and am having some problems. i tried researching the proper way but apparently failed.
when left alone the light will come on on its own with the switch in the off position.
i first installed an auxilary fuse box not tied in to the ignition so i could wire other things there as needed. i ran the light bar to a relay and the relay is powered off of the new fuse panel. the switch to run the relay is also run off of the same fuse panel. light is grounded. relay is grounded and switch is grounded. i am thinking about eliminating the relay as the light rated at 4 amps and the switch is 15 amps.
anything obvious i did wrong?
is the best and easiest just to go through the switch?

Utah RZR Rentals

whence