No message available, Or messages are expired already.

Made a quick disconnect fire extinguisher mount for about $8Attachment 558510Attachment 558512Attachment 558514Attachment 558516.

Materials:
24” Shelf wall bracket
2 – 1 3/4 – 2 3/4” hose clamps
2 – hose clamps that will fit around extinguisher of your choice
2 – 1/4 x 1 1/4” ring detent pins

Cut desired length of bracket for mount (I did about 7”). You will need 2 of these. Round cut edges off with sanded or grinder.

Using a punch and hammer bend out two of the middle tabs on each piece for the hose clamps to pass through.

Clamp both pieces together with c-clamps and drill through all 4 layers in two places with a 1/4” bit. Changer these holes slightly with a larger bit.

Assemble on roll bar of RZR. 5/16” shrink wrap fits perfect over the hose clamps for a better appearance. Of pins are too tight wallow the holes slightly until you are happy with the fit.

Sent from my iPhone using RZRForums.net

Attached Thumbnails


 



 



 



 

Utah RZR Rentals

whence