Having purchased a new 2017 XP 1000 and liking the looks of the SuperATV rear brush guards (bumper) I bought one. After mounting it to the unit I found that the upper half’s mounting bungs don’t fit flush to the frame … only a small portion actually touches the frame. The gap is so wide at the top you can actually see the mounting bolt.

I contacted SuperATV about this as it appears as if the bung was welded on 180* off not allowing for a flush fit. I sent them pictures and got a response saying that it fits fine.

Do those of you who have the SuperATV rear bumper find the same issue? Just doesn’t make sense to have one small portion mount to the frame where any slight impact could crush into or slice the frame.

Utah RZR Rentals

whence