yet another attempt at a sticky for the forum. this one is based on the xp1k 16 and newer, 14 & 15 can only do reverse shaft unless changing to a 16 secondary clutch that matches the input shaft. if there are corrections or additions, please PM me and ill get it added or corrected.

OPTION #1: A reverse shaft change of 12% across all 3 ranges- 570 gear set PN’s 3235380 27T and 3235381 46T

OPTION #2: 26% across all 3 ranges- 325 gear set PN’s 3235451 25T and 3235450 48T

OPTION #3: 21% Low range only- this would be swapping to the xpt2 2 piece shaft 3235987 and install ranger low gear set 3235232 67T and the 3236132 25T

OPTION #4: 33% Low range, 12% Reverse and High- same as #3 but add 570 set.

OPTION #5: 33% Low range, 12% Reverse and 8% High- this would take swapping to the xpt4 2 piece shaft 3235988, add the ranger low set, and the ace 570 set

OPTION #6: 47% Low range, 26% Reverse and 26% High- swap to the xpt2 2 piece shaft, add ranger low gear set, and the ace 325 gear set.

OPTION #7: 47% Low reduction, 26% Reverse reduction, 22% High reduction- Start with an 18’ XPT4 input shaft PN 3235988, add the ranger low set 3235232 & 3236132, then add the 325 gear set 3235451 & 3235450.

Utah RZR Rentals

whence