Good Morning,

Wrapping up my rugged radio setup and trying to figure out how to route the antenna wire. I am going to mount it at the center of my cage in the rear. As of now I am routing it down the C Pillar through the rear, then down the middle of the rzr.

I wanted to then go up into the front of the rzr and through the rubber grommet back into the dash area to access the back of the radio… one small issue… antenna wire isnt long enough. Its long enough if I wanted to drill the center console plastics (above the cup holders) and go straight to the radios.. which I could do but just wouldnt be a clean install.

Any thoughts?

Also.. any way to remove either end of the wire without cutting it? Was a pain to route near the C pillar with that nut on the end.

Utah RZR Rentals

whence